ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: + ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. Manufacturer of Carbon steel WPHY 60 pipe fittings, Exporter of a comprehensive range of products like CS ASTM A elbow, Reducer, Effortless ordering and.

Author: Doutilar Masida
Country: Anguilla
Language: English (Spanish)
Genre: Business
Published (Last): 7 October 2010
Pages: 103
PDF File Size: 8.29 Mb
ePub File Size: 12.90 Mb
ISBN: 391-7-14917-753-8
Downloads: 65724
Price: Free* [*Free Regsitration Required]
Uploader: Akill

If used on small? NDE personal shall be. After the removal of any cracksthe tees shall be re- examined by the removal of any Acceptable tees shall be astk with the symbol PT or MTas applicableto indicate compliance.

A860 WPHY 65 PIPE FITTTINGS

This specification covers wrought high-strength low-alloy butt-welding steel fittings of seamless and electric fusion-welded construction for applications in high-pressure gas and oil transmission and distribution systems. Rejection and Rehearing No cracks shall be permitted. In addition, if requested to provide test reports, the manufacturer shall also provide the following, when applicable: These fittings are for use in high — pressure gas and oil transmission and distribution system.

The results shall conform to Table 1 for either heat or Speci?

  KANZASHI IN BLOOM BY DIANE GILLELAND PDF

Individual reprints single or multiple copies of this standard may be obtained by sstm ASTM at the above address or at phonefaxor service astm. Fittings formed above the transformation temperature or upon which welding is performed, shall be cooled to below the lower critical temperature prior to heat treatment.

Size, mm 10 7. This abstract is a brief summary of the referenced standard.

ASTM A WPHY GR 60 Pipe Fittings, Carbon steel WPHY 60 buttweld fittings Manufacturer, Exporter.

JIS G Carbon steel pipes for ordinary piping. Section V, Nondestructive Examination. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. No cracks shall be permitted. Within the text, the SI units are shown in brackets. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Rectangular specimen for thickness less than 5? And over, Asfm tested Section;min, specimen, thickness [7. The material for fittings shall be fully killed fine — grain material made by a. JIS G Carbon steel pipes for pressure service.

A860 WPHY 60 PIPE FITTTINGS

The testing shall be performed as speci? Committee A01 has identi? Link to Aatm This link will always route to the current Active version of the standard. A chemical analysis shall be performed on deposited weld metal for each heat of? Specimens shall conform to required values of chemical composition and mechanical properties, namely: Current edition approved Nov.

  AUTION MAX AX-4280 PDF

After the removal of any cracksthe tees shall be re. Materials and Manufacture … Research use only,Commercial use is prohibited.

There sults shall conform to Table 1 for either. The nickel content of the deposited weld metal.

Electrodes for the shielded metal-arc process shall be of the low-hydrogen type. The requirements are not intended to give assurance against fracture propagation. All values are Maximum unless A range is stated. Full size Charpy, V-notch specimens shall be used whenever possible.

The product analysis shall be the basis for rejection. Acceptable tees shall be marked with the symbol PT or MT, aetm applicable, to indicate compliance.