Note: Data is maintained by an independent source and accuracy is not guaranteed. Check with the manufacturer’s datasheet for up-to-date information. 3-state Octal D-type Transparent Latches and Edge-triggered Flip-flops DM74LS 3-STATE Octal Details, datasheet, quote on part number: 74LS, 74LS Datasheet, 74LS Octal D Flip-Flop, buy 74LS, 74LS pdf, ic 74LS
|Published (Last):||21 September 2012|
|PDF File Size:||9.17 Mb|
|ePub File Size:||13.39 Mb|
|Price:||Free* [*Free Regsitration Required]|
74373 Datasheet PDF
A buffered output control input can be used to place the. When the Dataasheet pin is low input data will appear in the output.
Q outputs will follow the data Datasyeet inputs. I have 5V on D, but only get 3. That is, the old data can be. The output control does not affect the internal operation of.
Order Number Package Number. When the enable is taken LOW the output will be latched at the level of the data that was set up. That is, the old data can be retained or new data can be entered even while the outputs are OFF.
(PDF) 74373 Datasheet download
In the high-imped- ance state the outputs neither load nor drive the bus lines significantly. Notify of all new follow-up comments Notify of new replies adtasheet all my comments.
But when the OE is high the output will be in a high impedance state. Video games, blogging and programming are the things he loves most. Fairchild Semiconductor Electronic Components Datasheet.
They are particularly attractive. A buffered output control input can be used to place the eight outputs in either a normal logic state HIGH or LOW logic levels or a high-impedance state. The following two tabs change content below.
The IC 74LS is a transparent latch consists of a eight latches with three state outputs for bus organized systems applications. The eight flip-flops of the DM74LS are edge-triggered. Frank Donald October 27, 2 Comments. This IC operates with maximum of 5 V and widely dstasheet in many kinds of electronic appliances.
Quote and Order 743773 in minutes on: On the positive transition of the clock, the Q outputs will be set to the logic states that were set up at the D inputs. Here is the Link for the datasheet kindly take a look at the electrical characterstics, hope this helps. Do I need pull up resistors or does this sound like bad chips. Frank Donald is an Electronics datassheet Communication Engineer who loves building stuff in his free time.
OE is held tied to ground. The high-impedance state and. Latest posts by Frank Donald see all. The output control does not affect the internal operation of the latches or flip-flops.
– Octal D-type transparent latch; 3-state – ChipDB
But when the Latch Enable Pin was pulled low, the data will be latched so that the data appears instantaneously providing a Latching action. Devices also available in Tape and Reel. The high-impedance state and increased high-logic level drive provide these registers with the capability of being connected directly to and driving the bus lines in a bus-organized system without need for inter- 7433 or pull-up components.
Q outputs datasneet be set to the logic states that were set up at. On the positive transition of the clock, the. As we all know the operation of flip flop that any input to the D pin at the present state will be given as output in next clock cycle.